Direct View LED DisplaySuport - ViewSonic Romania

Why can't RS232 be used to Power on/off the DVLED Display while in Standby Mode?

Currently, RS232 cannot Power on/off a DVLED display while in Sleep Mode. Check the On-Screen Display (OSD) settings to see if the Standby Mode is set to Sleep Mode. Solution 1. To Power on/off a DVLED display using RS232, switch the Standby Mode in the On-Screen Display (OSD) settings to Hibernate Mode. 2. The DVLED disp...

What should I do if the LED(s) on the DVLED display is unlit?

Answer: Please refer to the LED dead pixel specification in the User Manual to determine if it needs replacing, or contact the local service provider for proper assessment. Click each model to view detailed replacement specificationsDeactivated pixels determination for LED module replacement based on Acceptance Criteria for 1) whole dis...

What are the Product dimensions and weight for dvLED displays?

Refer to the tables below for dimensions and weight by dvLED product. LD108-121 Width Height Distance Weight w/o wall mount 95.31” (2420.8mm) 57.81” (1468.45mm) 1.38” (35mm) 194.01 lb (88 kg) With wall mount 95.31” (2420.8mm) 57.81” (1468.45mm) 2.2” (56mm) 209.44 lb (95kg) LD135...

What are the differences between TFT LCD and Direct View LED (dvLED)?

The core difference lies in the light source: TFT LCD uses a backlight filtered through liquid crystals, whereas dvLED features self-emissive pixels that turn on/off individually for superior contrast and efficiency. Comparison Highlights: Light Emission: TFT LCD requires a constant backlight, while dvLED is self-emissive, meaning each...

I need detailed product dimensions, where can I find Mechanical drawings of DVLED products?

Mechanical drawings will vary by model. The mechanical drawings can be found for the appropriate User Guide. Solution LD108-121: LD135-151: LD163-181: LD216-251:

What is the LED Module installation order of the DVLED Displays?

The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...

How do I remove LED Modules from the DVLED Display?

Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...

When should dehumidification be done for my DVLED?

Dehumidification should be done when the dvLED display is: being installed for the first time, in a rainy season, a snowy season, and/or in a coastal area, un-used for a long time (3+ months)

What is the Bracket installation order of the DVLED Wall-mount configuration?

The Bracket installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Appropriate location and center point found for installation (e.g. upper bracket mounted at least two meters above the ground for a 135" LED display; for other display sizes, check corresp...

How do I install a DVLED display with a Floor Stand configuration?

Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Floor Stand Step 2: Install the System Control Box onto the Floor Stand Step 3: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 4: Install the LED Modules onto the Cabin...