The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...
These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...
Input lag means the time difference between when user controls PC and sees the response on monitor. There is a trade-off to picture/video performance. If no particular demand, it is suggested to set it to off.
Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...
Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...
Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...
To enable 180Hz refresh rate on your monitor, you need to turn on Overclocking in the monitor's On-Screen Display (OSD) Menu. After turning on Overclocking, you then can set the refresh rate to 180 Hz under your computer's “Display” settings. For example, in Windows go to Settings > System > Display > Advanced display to set the refr...
To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...
MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...
Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2? NO