Currently, RS232 cannot Power on/off a DVLED display while in Sleep Mode. Check the On-Screen Display (OSD) settings to see if the Standby Mode is set to Sleep Mode. Solution 1. To Power on/off a DVLED display using RS232, switch the Standby Mode in the On-Screen Display (OSD) settings to Hibernate Mode. 2. The DVLED disp...
Answer: Please refer to the LED dead pixel specification in the User Manual to determine if it needs replacing, or contact the local service provider for proper assessment. Click each model to view detailed replacement specificationsDeactivated pixels determination for LED module replacement based on Acceptance Criteria for 1) whole dis...
Refer to the tables below for dimensions and weight by dvLED product. LD108-121 Width Height Distance Weight w/o wall mount 95.31” (2420.8mm) 57.81” (1468.45mm) 1.38” (35mm) 194.01 lb (88 kg) With wall mount 95.31” (2420.8mm) 57.81” (1468.45mm) 2.2” (56mm) 209.44 lb (95kg) LD135...
The core difference lies in the light source: TFT LCD uses a backlight filtered through liquid crystals, whereas dvLED features self-emissive pixels that turn on/off individually for superior contrast and efficiency. Comparison Highlights: Light Emission: TFT LCD requires a constant backlight, while dvLED is self-emissive, meaning each...
Mechanical drawings will vary by model. The mechanical drawings can be found for the appropriate User Guide. Solution LD108-121: LD135-151: LD163-181: LD216-251:
The LED Module installation order is the same for the Wall-mount and Floor Stand configuration. Please follow the steps in the respective order for the LED module installation order: Anti-static gloves worn Began handling with delicacy, following numbers marked on the box of each module Confirmed arrow facing upwards when installing the LE...
Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...
Dehumidification should be done when the dvLED display is: being installed for the first time, in a rainy season, a snowy season, and/or in a coastal area, un-used for a long time (3+ months)
The Bracket installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Appropriate location and center point found for installation (e.g. upper bracket mounted at least two meters above the ground for a 135" LED display; for other display sizes, check corresp...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Floor Stand Step 2: Install the System Control Box onto the Floor Stand Step 3: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 4: Install the LED Modules onto the Cabin...