Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...
Replace the batteries and ensure there are no obstructions between the remote and the projector's IR receiver. Replace Batteries: Insert a fresh set of batteries. Low power can cause intermittent operation even if the remote’s indicator light turns on. Clear Obstructions: Ensure the [IR Receiver] on the projector is not blocked by any ...
Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...
Use the "Reset All Settings" or "Factory Reset" option in the menu to revert all configurations to their original state. Standard Projector Menu: Press [Menu] on your remote. Navigate to [System Setting: Advanced]. Select [Reset All Settings] and confirm. Smart Projector Menu (M-series / X-series): Go to the Home Screen...
Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...
Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...
Adjust the image size by changing the "Throw Distance," rotating the "Zoom Ring," or using the "Digital Zoom" setting in the menu. Adjust Throw Distance (Physical): This is the most effective method. Move the projector further from the screen for a larger image, and closer for a smaller one. Use the Zoom Ring (Optical): Rotate t...
Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...
Auto-shutdown is typically triggered by overheating protection. Ensure proper ventilation, clean the dust filters, and enable "High Altitude Mode" if necessary. Check LED Indicators: If the Temp light is red or flashing after shutdown, the projector has overheated. Improve Airflow: Keep at least 50cm of clear space around intake an...
Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...