Commercial DisplaySupport - ViewSonic Asia Pacific

The image is distorted from NMP-302w HDMI out, how can I do?

You can refer below steps to check the issue. 1. To reset the NMP-302w. 2. To replace the HDMI(extension) cable. If above steps can't solve the issue, it will be NMP-302w mainboard issue, you need to replace NMP-302w.

CDX5560 / CDX5562 Video Wall Installation Addendum

To avoid screen damage, always handle the display by the back handles. Always place the display on a cushion pad after removal from the carton box. Please do not remove the rubber cushions around the display for a video wall installation. You may remove the rubber cushions around the display for a single screen installation.

What is tilling mode for Videowall and how to set it correctly?

<Tiling Mode> In Tile Mode you can view an image in a larger scale by connecting multiple monitors. After all the displays are installed properly to a video wall, you need set the position of each display to determine how to display the input image. Once the position is set, the video source (e.g. computer) identifies the number of connect...

What are the communication settings to control IFP via RS232 and LAN commands?

RS232 Communication Setting - Baud Rate Select: 9600bps (fixed) - Data bits: 8 bits (fixed) - Parity: None (fixed) - Stop Bits: 1(fixed) LAN Communication Setting - Type: Ethernet - Protocol: TCP/IP - Port: 5000 (fixed) - Cross subnet: No - Logon Credentials: No

What are the requirements or limitation on the using cables of Videowall?

Support HDMI Ver. 1.4b DVI cable can't exceed 5M, otherwise, a DVI extender is required HDMI cable can't exceed 5M, otherwise, a HDMI extender is required LAN Cable can't be used to carry video signal directly Signal cable for each display should be separated from each other, twists cables together is not allowed Device for signal transmi...

ViewSonic CDE30 Series Power Save Modes: Which Mode Should I Use?

ViewSonic CDE30 Series power save modes: Which mode should i use? There are four Power Save modes to choose from and knowing which one to use depends on the application. For this scenario we will cover digital signage, information and monitoring systems and meeting rooms where always-on, wake up on active signal and fast boot time is a must...

Does NMP-302w and NMP580-W support touch content?

NMP-302w and NMP580-W support EP5520T touch function, you can use these two models with EP5520T, then you will have touch function.

How can I fix EP5520T into floor?

Please refer the attachment. Attachment URL:https://support.viewsonic.com/helpdesk/attachments/33010268005

How can I add other widgets to the Signage manager software?

You can refer below steps to use other widgets.

How many touch points can I get from a multi-touch display on CDE models with touch?

Please refer to below table: OS/Model/touch points CDE**61T CDE8452T Win 7 (except Starter and Home Basic) Win 8/8.1/10 20 points touch 10 points writing 10 points touch 5 points writing Linux (Kernel >=2.6.32 by patch) (Kernel >=3.5) 20 points touch 10 points writing 10 points touch 5 points writing An...